Wall Mount Installation

The film is tough, but can be damaged by fingernails or sharp instruments. If cared for properly, it should
last indefinitely. Handle by holding along edges, only do not press down on mirror surface with your thumbs when holding mirror along edge. Do not put any weight or object on mirror surface when it is in a horizontal position.

Hardware, already attached to the mirror panel, includes:

4 brackets

4‐#10 self tap screws

Installation instructions:

    1. It is recommended that two people mount the mirror panel.
    2. Every panel has predrilled holes. To install the mirror panel in a horizontal position,remove self tap
      ping screws and brackets. Install them in the holes located approximately 19/16” from each corner
      on the side of the mirror.

    1. Locate position of mirror panel on wall marking the spots for the mounting holes of the brackets.
    2. Drill the four holes in the wall using a drill size suitable to the type of wall fastener (not included) you intend
      to use. The mirror panel can be mounted in two different ways:

Cleaning Instructions:

Before attempting to clean the mirror, use dry compressed air to make sure all dust and debris are off the mirror
surface (i.e.Dust Off). To easily clean finger marks or splashes, use a window cleaner by wiping gently with a soft,
non‐abrasive cloth. Any dust or hard particles in the cloth or on the mirror may scratch the film surface. Should
the film adhere to the backing panel, blow gently into the vent hole in the back ofthe panel.